SGS Rubber Pad Vulcanizing Press,
2.2kw Rubber Vulcanizing Press,
PLC Rubber Vulcanizing Press Machine
We have a separate processing plant, there are a lot of inventory.
Hydraulic rubber hot plate vulcanizing press/Rubber Curing Press For Vulcanization Machine:
Our factory has nearly 30 years' experience in manufacturing rubber machine.
Fully Automatic Rubber Product Making Machine/rubber blanket curing press
We have a set of standardized production line, which contains wire peeling machine, rubber cutter,
Grinding mill, shredder, screen conveyor, rubber crusher, shaker, banburying mixer, open mill, spiral elevator,
Kneader, rubber filter and extruder, vulcanizer, refiner, calendering machine
1. Frame Hydraulic Tire Vulcanizing Press is composed of hot plates, plates, up and down platforms, piston stroke, hydro-cylinder, hydraulic station and electrical control system. It can be equipped with push-pull mould device to move the mould on the machine.
2. Plates are constituted with welded Q235 steel plates through mechanical ball blast rust removal, spraying zinc rich series paint, shake to remove stress, then transferred into mechanical producing.
Hot plates are obtained by 35# steel plates after normalizing handling and then adopting double scale rolling. It is equipped with a set of electric control valves to realize the automatic adjusting of steaming temperature.
3. Up and down platforms adopts Q235 steel plates. In order to guarantee the make precision, it is applied with automatic cutting baiting, mechanical slicer producing welded groove, carbon dioxide gas shielded welding. It all adopts alloy welding wire welding and after welding takes whole enter into stove to go on the hot treatment to remove the welding stress exhaustively.
Hydro-cylinder adopts ZG270-500 and piston stroke adopts hard cold chilled alloy cast iron. And sealing structure applies the combined structure with double sealing ring and one dustproof ring to guarantee longer service.
4. Electrical control system adopts PLC automatic control to realize automatic closing, opening mould and gas exit equipment. It can also switch into hand control.
5. Before leaving factory, this plate vulcanizing press needs to pass 48 hours' pressure test, pressure maintaining to test the bearing of the hydro-cylinder and piston stroke and guarantee no oil leakage and seeping to avoid unnecessary quality problems.
6. We can design and manufacture all kinds of non-standard plate vulcanizing press according to the customers' definite requirements.
Contact Person: Stephen Yang